Alkaline oxygen evolution: exploring synergy between fcc and hcp cobalt nanoparticles entrapped in N-doped graphene

Herein, we report a Mott-Schottky catalyst by entrapping cobalt nanoparticles inside the N-doped graphene shell (Co@NC). The Co@NC delivered excellent oxygen evolution activity with an overpotential of merely 248 mV at a current density of 10 mA cm^–2 with promising long-term stability. The importance of Co encapsulated in NC has further been demonstrated by synthesizing Co nanoparticles without NC shell. The synergy between the hexagonal close-packed (hcp) and face-centered cubic (fcc) Co plays a major role to improve the OER activity, whereas the NC shell optimizes the electronic structure, improves the electron conductivity, and offers a large number of active sites in Co@NC. The density functional theory calculations have revealed that the hcp Co has a dominant role in the surface reaction of electrocatalytic oxygen evolution, whereas the fcc phase induces the built-in electric field at the interfaces with N-doped graphene to accelerate the H⁺ ion transport.     

Strongly localized states in a single carbon nanotube with polymer molecules

A single-walled carbon nanotube (SWCNT) with conjugated polymer molecules is analyzed via optical spectroscopy. The presence of strongly localized excitonic states in the SWCNT is confirmed using time-integrated photoluminescence (PL). The PL spectrum exhibits extremely narrow width (~0.8 meV) which is attributed to the strong confinement of the states by polymer molecules. In addition, I observed that the excited states are gradually filled as a function of the excitation power, which supports the localized excitonic behavior. Only the ground excitonic state is observed at low excitation powers, but three additional PL peaks appear as the excitation power is increased. Especially, the power-dependent PL spectrum shows a blueshift and increased width, which can be elucidated in terms of quantum confined stark effect and the screening of induced electric fields. Overall, I demonstrate that the presence of polymer molecules induces several localized states in a single SWCNT.     

A modern approach to the solution and analysis of the Simha-Somcynsky model for the description of pressure-volume-temperature properties of polymer fluids

We revisit the Simha-Somcynsky model of polymer fluids with the purpose of developing novel theoretical and computational approaches to simplify and speed up its solution as well as the fitting of experimental data, and decrease its level of mathematical complexity. We report a novel method that allows us to solve one of the two equations of the model exactly, thus putting the level of mathematical difficulty on a par with the one of other models for polymer fluids. Moreover, we describe a computational algorithm capable of fitting all five parameters of the model in an unbiased way. The results obtained reproduce literature results and fit experimental pressure-volume-temperature and solubility parameter data for three polymers very accurately. Moreover, the new techniques allow for the investigation of the model at very low temperatures. Unexpectedly, the model predicts behaviors that could be interpreted as a glass transition, as routinely observed in dilatometry and differential scanning calorimetry, and a glass phase. We compared the predicted and experimental T g’s for cis poly(1,4-butadiene) and found an excellent quantitative agreement.     

Statistics of polymer capture by a nanopore: A Brownian dynamics simulation study

We investigate the statistics of polymer capture by a nanopore using Brownian dynamics simulations. It is found that when the velocity flux is greater than a critical velocity flux, the capture picture is a random selection process, otherwise it tends to a statistical process governed by energetic considerations. In addition, the chain ends capture probability decreases as the chain length increases and satisfies a power-law scaling of P0(N)~N-0.8.     

双掺(Tm3+,Tb3+)LiYF4激光器1.5 μm波长激光阈值分析

由速率方程推出了双掺（Tm^3 ,Tb^3 ）离子准四能级系统的激光阈值解析式，讨论了Tm^3 和Tb^3 离子之间的相互作用。分析了1.5μm波长附近的激光阈值和Tm^3 、Tb^3 离子的掺杂原子数分数及晶体长度的关系。结果表明，对于对应Tm^3 离子^3H4→^3F4跃迁的约1.5μm波长的激光，激活离子Tm^3 的掺杂原子数分数过大时，交叉弛豫作用将使系统阈值迅速增加。Tb^3 离子的加入，一方面能抽空激光下能级，起到降低阈值的作用；另一方面亦减少了激光上能级的寿命，使阈值升高。故Tb^3 离子有最佳掺杂原子数分数。对于Tm原子数分数为y=0.01的Tm:LiYF4晶体，Tb^3 离子的最佳掺杂原子数分数为0.002左右，同时表明，激光阈值与晶体长度有关。最佳晶体长度与Tm^3 、Tb^3 离子的掺杂原子数分数以及晶体的衍射损耗和吸收损耗有关。     

Phase separation in blends of two homopolymers and a diblock copolymer during film casting

Demixing during film casting of blends of polystyrene, polymethylmethacrylate, and a symmetric diblock copolymer of styrene and methylmethacrylate is discussed. The concentration fluctuations in the homogeneous solutions were calculated in mean field approximation. The structures in the homogeneous and demixed solutions and in the dry films were measured by small-angle x-ray scattering, and the morphologies of the dry films were characterized by transmission electron microscopy. The structure of the dry blends is evidently already pre-formed in solution.     

Characterization of ZnO:AI films deposited by r.f.magnetron-sputtering at low temperature

Transparent conducting ZnO:AI thin films with good adhesion and Iow resistivity have been prepared on organic substrates and Coming 7059 glass substrates by r.f. magnetron-sputtering technique at Iow substrate temperature (25-210℃). Structural and photoelectric properties of the deposited films are investigated. The deposited films are polycrystalline with hexagonal structure and a preferred orientation with the c-axis perpendicular to the substrate. Only the (002) peak is observed.High quality films with resistivity as Iow as 1.0 x 10- 3Ω@ cm and 8.4 x 10- 4Ω@ cm, the average transmittance over 74% and 85% in the wavelength range of the visible spectrum have been obtained on different substrates.     

甲基紫掺杂聚乙烯醇薄膜材料红光多重全息存储

甲基紫掺杂聚乙烯醇薄膜材料在两束相干光照射下生成相位光栅.当改变一束相干光光程,通过监测相位光栅的一级衍射信号强度的变化,可以检测相位光栅的生长和擦除过程.在此实验基础上,讨论了甲基紫掺杂聚乙烯醇薄膜材料多重全息存储的原理与结果.     

掺钕聚甲基丙烯酸甲酯的光学特性

研究了制备的掺钕螯合物Nd(DBM)3Phen材料的吸收光谱、激发光谱、荧光光谱,应用Judd-Ofelt理论计算了该材料的强度参量．分析了钕离子激发态4F3／2的辐射寿命(631 μs)和4F3／2→4IJ′跃迁的受激发射截面和荧光分支比．     

Single-mode rib polymer waveguides and electro-optic polymer waveguide switches

Mode-matching and effective index methods are used to analyze single-mode operation of optical rib polymer waveguides. Their single-mode waveguiding conditions are determined. Single-mode rib waveguides fabricated from guest–host polyetherketone are presented. The estimated propagation loss of straight rib-waveguides is 0.7 dB/cm at 1.55 μm. Furthermore, by using the mode field-transfer matrix method, 2×2 and 4×4 polymer Mach–Zehnder interference switch operating at 1.55 μm wavelength has been designed based on optical multi-mode interference.